NISSAN FRONT END RECEIVERS

 

ModelYearNotesPART#Line PullTWPrice

Frontier- Pickup

>>>Click Here For Instructions

05-13

NO Drilling Required
Remove Lower Fascia and Tow Hook

C31241s

9000

350

$129.99

Pathfinder

>>>Click Here For Instructions

05-14

NO Drilling Required
Remove Lower Fascia and Tow Hook

C31241s

9000

350

$129.99

Titan 4 X 4

>>>Click Here For Instructions

04-10

Remove Tow Hooks C31199s 9000 500 $135.00
Titan 4 X 4

>>>Click Here For Instructions
 

09-13

Drilling Required
Temporarily Remove Tow Hooks
Fishwire Hardware
C31061ns 9000 500 $163.99
Xterra - All Models 

>>>Click Here For Instructions

 

05-12

NO Drilling Required

Tow Hooks must be removed

C31514ns

9000

350 $169.00
   NOTE: *IF IT DOES NOT STATE "ND" THEN DRILLING IS REQUIRED*

ND - No drilling required

ej - Will not fit limited model

fs - Temporary removal of front bumper required

eg - Plastic shield may require cutting obtain customer approval prior to installation

ek - Receiver fits behind license plate, requires #5443 sold separately.

fx - Some vehicles may require adjustment of front license plate.

eh - Will not fit with factory flare package el - Front Air-Dam will have to be trimmed or removed. fy - Some minor drilling required to enlarge holes in fascia
ei - Designed to fit with close tolerances, vehicles with damaged bumpers or front end damage will encounter difficulty with installation. et - Small area of the shroud needs to be trimmed. fu - This front end receiver can only be used on vehicles with factory installed tow hooks.  A supplementary support kit 5412-KT must be ordered to use this Front End Receiver on vehicles that do not come equipped with factory tow hooks
x - Minor Fascia Trimming Required KG - Requires optional skid shield to be removed (if present) gy - Factory fog lights need to be removed to install hitch They cannot be reinstalled at factory locations.
hm - Receiver fits behind license plate, requires a fold up license plate adapter HH8802 or license plate adapter HH5443 sold separately. Trimming of the existing license plate holder will be required when using the HH8802. JT- 2 WD Models Only JV-Rubber air deflector/fascia must be removed or trimmed to install
JY - Extensive Fascia cutting required on models w/fog lamp option HB- Fascia deformation may occur on some models Tech tip: Vehicles with skid shield require removal of or major modifications to skid shield for re-installation with hitch.
   
trans.gif (43 bytes)